Chapter 2- Component Replacement
3Carefully slide the Power Supply unit out from the front slot.
4Slide in the replacement Power Supply unit.
5Push the Power Supply unit firmly into the Backplane, making sure it is properly seated in its slot, and that the latch is in a locked position.
6Tighten the captive screws on the front panel of the Power Supply unit to the chassis.
Replacing an AC Power Entry Module (PEM)
On the rear of the RMX three AC PEM’s are fitted, each with their own power cord.
Use the following procedure to replace a Power Entry Module (PEM):
Please verify the type of PEM used on your RMX 4000. Do not insert a PEM of a different type on your system.
1Unplug the Power cord connected to the failed PEM unit.
2Unscrew the captive screws on the rear panel of the PEM unit that secures the unit to the chassis.
3Using the handle fitted to the PEM, pull the PEM unit out.
