System Installation

Install Shelves

Rack mount

To install shelves in the rack, slide the shelves into the rack and secure them to the rack using 8 screws, 1/4” minimum length.

Wall mount

At this point in the installation process, there should be a backboard securely fastened to the wall and mounting screws partially inserted into the backboard. See Chapter 4, section Prepare Location for Shelves for more information.

To attach the shelves to the wall:

1.Remove all cards from the shelf. Do not mount the shelf with cards installed.

Cards contain components that may be damaged by electrostatic discharge. Before handling any of the cards, attach the grounding strap (included in the Administration Kit) to your wrist, and attach the other end of the strap to ground. Handle cards only by their edges. Do not touch connector contact areas. Do not lift cards by any of the components. Do not lay cards down on their component sides. When laying a card down, place it component side up, on top of the anti-static bag in which it was shipped.

2.Position the MCS300 so that the six mounting screws are aligned with the six keyhole openings in the back of the shelf.

3.Slide the shelf down onto the screws to lock the shelf into place. Check that all six screws are properly locked.

4.Tighten all six screws fully.

Do not install cards until power is connected.

PN: 1725-36122-001_M.doc

41

Page 41
Image 41
Polycom 1725-36122-001, MCS300, JPI300 manual Install Shelves, Rack mount, Wall mount