Door Frame
Sectioning—Outer
(Front Hinge Pillar)
1
Installation Procedure
1. Cut the replacement service part in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of
2. In the Front Hinge Pillar, create a
1
50 mm (2 in.) backing plate (1) from the unused portion of the Door Frame Opening. Trim the backing plate as necessary to fit behind the sectioning joint.
3. In the rocker locations, create a 100 mm (4 in.) backing plate (2) from the unused portion of the door frame opening. Trim the backing plate as necessary to fit behind the sectioning joint.
2
4. Drill 8 mm (5/16 in.) plug weld holes along the sectioning cut on the remaining original part
2001 Pontiac Aztek
