Rail Sectioning—
Rear
Removal Procedure
IMPORTANT: Rear rail sectioning may require replacement of the rear floor panel.
1. Remove all related panels and components.
2. Restore as much of the damage as possible to factory specifications.
3. Note the location and remove the following as necessary:
•
• Sound deadeners
• Sealers
IMPORTANT: Do not damage any inner panels or reinforcements.
4.Perform the necessary procedures to gain access to the rear rail.
5. Locate and drill out all factory welds. Note the number and location of welds for installation of the rear rail.
6.Mark the cut location by measuring 5 mm (1/4 in.) from the rear edge of the second gauge hole rearward
7. Cut the rear rail section.
5mm
(0.25 in)
8. Remove the damaged rear rail section.
