Primera Technology Network Disc Duplication & Printing System user manual Cleaning the XRN

TOC INDEX

B. CLEANING THE XRN

Use a clean, lint-free rag with a small amount of ammonia window cleaner to clean the XRn's outside case and trays. This type of cleaner is very effective on inks that may accumulate on the printer tray. Stronger cleaning solutions are NOT recommended because they may damage the paint and plastic materials from which the parts are manufactured.

Always disconnect the XRn’s power cords before cleaning. Resume operation only after the surfaces are completely dry.

C. PERFORMING A ROBOTIC SELF-TEST

To ensure that everything is working properly, a Self-Testfeature is built in to your unit. In this mode, the Robotic Disc Transporter will go through the motions of picking and placing a disc to ensure proper working order. Perform the test by doing the following steps:

•Load some discs into the Right Bin

•The cover must be closed for this operation to complete. However, in order to access the buttons you must open the cover. To get around this problem simulate closing the cover by activating the cover lock sensor. You may do this by putting an object such as a folded piece of paper in the slot where the lock would normally be located.

•With the unit turned on, press the Cartridge Button

•While holding the Cartridge Button, press the

Power Button until the robotics start to move.

•Release both buttons

•To stop the test, wait until the disc has moved to the Right Bin and press the Power Button.

42Maintenance and Troubleshooting