ProScan CRT Television manual 33,37, RRCA, ProScan, or GE Codes

Programming the Universal Remote to Control a

Laserdisc Player, DVD Player, or Second VCR

-Ihe remote'sDVDoVCR button is preprogrammed to control the primary functions of a ProScan, RCA, or GE DVD player. If you would like this button to control a component other than a DVD player, you can program the remote to control a laserdisc player or VCR. For a ProScan, RCA, or GE component, just use the codes shown to the right.

If you ever need to reprogram the remote to control a DVD player, laserdisc player, or second VCR, use the codes shown to the right.

1.Turn on the laserdisc player, DVD player, or second VCR.

2.Look up your brand and its code number(s) on code list at right.

3.Pressand hold the DVD.VCR button on the remote.

.4. Enter the two-digit code from the code list.

5.Release the DVDoVCR button and pressPOWER or another button to see if the laserdisc player or DVD player responds to the remote commands.

6.Repeat these steps using the next code listed for your brand, until the laserdisc player, DVD player, or second VCR responds to the remote commands.

Programming the Universal Remote

to Control an Audio Component

To program the remote for a remote-controllable audio component, point the remote at the component and press the correct component button: AUX for an AV receiver, CD for a CD player, etc. Then, press POWER or CHAN up or down. If the component doesn'trespond, the remote needs to be programmed. Use the codes in the code list on the next page or on the sheet packed with your remote. However, this remote may not operate all models of the brands that are shown in the code list.

Follow these steps to program your universal remote to control your audio component:

1.Turn on the component to be programmed.

2.Look up your brand and code number(s) on the code list.

3.Pressand hold the component button on the remote.

4.Enter the two-digit code from the code list.

5.Release component button, then press POWER to see if the component responds to the remote commands. If it doesn't,try pressing the component button, then POWER again.

6.Repeat steps 3 through 5 using the next code listed for your brand until the component responds to the remote commands.

VCR	33,37
Laserdisc player	33,37
rRCA, ProScan, or GE Codes 1
DVD player	78

26