ProScan CRT Television manual Programmingthe Universal Remote

PROGRAMMINGTHE

UNIVERSAL REMOTE

You can program the universal remote to control most brands of remote controllable TVs, VCRs, and cable boxes. If you have an PROSCAN, GE, or RCA VCR, you may not need to program the remote at all. Other manufacturer's brands need to be programmed.

Programming the Universal Remote to Control a VCR

[o determine whether you need to program the universal remote, turn on the VCR, point the remote at the VCR and press the VCR1 button. Then, press POWER or CHAN A or CHAN v to see if the VCR responds to the remote commands. If not, you need to program the remote.

Follow these steps to program your universal remote to control

your VCR:

1.Turn on the VCR to be programmed.

2.Look up your VCR brand and code number(s) in the code list on the next page or on the code sheet packed with your remote.

3.Pressand hold the VCR1 button on the remote.

. Enter the two-digit code from the code list.

5.Release VCR1, then press POWER to see if the VCR responds to the remote commands. If it doesn't,try pressing VCR1 and POWER to see if the VCR responds.

. Repeat steps 3 through 5 using the next code listed for your brand until the VCR responds to the remote commands.

VCR SAT,CABLE

AMoFM TAPEAUX

@ ® 0

REVERSE PLAY FORWARD

RECORD STOPPAUSE

CH GUIDE SKIP '_"

MUTE GO BACK

@@@

¢,@@

@@@

FAV'INPUTANTENNA

o @ o

INFO CLEAR RESET SCAN

MENU(_FETCH

SELECT

PIP POP SPt.IT CH CTRL

SIZE SWAP FR[[_E

This remote may not operate all models of the brands shown on the

next page.

To program the DVD.VCR button to control a secondVCR, follow the steps on this page, but use the DVD-VCR

button instead of theVCRI button.

For instructions on programming the

simple remote, see page 28.

•

22