Chapter 22: The 9160 G2 As Base Station
RRM Groups Configuration Settings
232 Psion Teklogix 9160 G2 Wireless Gateway User Manual
Status
This parameter enables or disables this slave base station.
Description
The name entered in this parameter is us ed as an alternate way of identifying the
IP address of a slave base station.
IP Address
This parameter provides the corresponding IP address for the slave base station.
The IP Address must be a unique value so that each slave base station can be ide n-
tified on the network.
The acceptable value ranges from 0.0.0.0 to 239.255.255.255.
The default value for the IP port is 16100.
Message Size
Message Size determines the largest single message that can be passed to a
terminal. The range of this parameter is between 32 and 380 characters. (Longer
messages are broken into several packets.)
For polling protocol base stations, the upper limit is 116.
Auto-Startup
When this parameter is enabled, the slave base stations will start polling when the
master 9160 G2 boots up. When Auto-Startup is disabled, the base stations will not
start polling until they receive a start polling command from the host.
22.4.2 RRM Groups Configuration Settings
While the 9160 G2 can operate as a Remote Radio Module (RRM, see “Connectiv-
ity Options: RRM Mode” on page 229), it can also control other RRMs. For a 9160
G2 to control RRMs, RRM groups must be configured. Once an RRM group has
been defined, from one to four RRMs can be members of a group.