R
EDGE 60 Pellet Fireplace
F. Finishing Material
2.Flush with the Mounting Frame
NOTICE:
It is important that the fi nishing material is determined before the appliance is secured to the fl oor. Depending on the fi n- ishing material and installation method, the appliance may need to be positioned further in or out of the wall.
There are three ways fi nishing material can be applied:.
1.Behind the mounting frame
2.Flush with the mounting frame
3.Protrudes beyond the mounting frame
1.Behind the Mounting Frame
The mounting frame is designed to have a 1/2 inch (13mm) overlap on the sides and the top of the framing opening.
Figure 28.1.
Finishing Material Behind
the Mounting Frame
Mounting Frame
Figure 28.1.
Positioning the nailing fl anges:
•Slide the nailing fl anges all the way to the front and this will set the appliance for 1/2 inch (13mm) sheet rock.
•If tile, marble or other fl at surface fi nish material is desi- ered and you want the mounting frame to cover the cut edge, set the nailing fl anges at a dimension of the sheet rock thickness plus the fi nishing material thickness.
Figure 28.2.
Example: Sheetrock = 1/2 inch (13mm)
Finish Material = 3/8 inch (9.5mm)
Move fl ange: 7/8 inch (22.5mm)
Front of Fireplace |
|
Adjustment Screw | 7/8 in |
| |
| (22.5mm) |
Adjustable Nailing Flange |
|
Figure 28.2
The fi nish material can not be thicker than
•Set the nailing fl anges for sheet rock thickness and install the appliance.
•Install the mounting frame.
•Install the fi nishing material to edge of the mounting frame.
Finishing Material Flush with Mounting Frame
Mounting Frame
Figure 28.3.
3.Protrudes Beyond the Mounting Frame
This method is mainly used for a brick or stone installa- tion. When fi nishing material is protrudes of the mounting frame and front, there must be a
Finishing Material Beyond Door Frame
Masonry Spacer
Door Frame
Maintain
Figure 28.4.
Use the masonry spacer supplied with the Front to position the fi nishing material at the proper dimension. Remember to keep the Front opening clearances in mind when fi nishing material is protrudes of the Front. (See pages
•Set the nailing fl anges for sheet rock thickness and install the appliance.
•Install the mounting frame.
•Install the fi nishing material to edge of the mounting frame.
•Complete the installation following all specifi ed clear- ances to combustibles.
December 6, 2011 | Page 29 |