R
EDGE 60 Pellet Fireplace
2.Soft Start Cycle (SS-Low / SS-Med)
Once the fi re is lit:
•The appliance moves into the low
•More fuel will be added
•As the fi re builds, the appliance will change to medium
•The heating cycle begins
5.Auto-Clean Cycle
The fi repot
•When the appliance is fi rst plugged in
•When the house reaches temperature and the appliance shuts down
•At prescribed intervals, depending on the type of fuel se- lected
•When starting up after an electrical interruption
3. Heating Cycle ( Auto / Man - L, ML, M, MH, H)
There are two choices in the Automatic / Manual menu of how your appliance will operate:
Automatic Mode
•The wall control will turn the heat output level up or down depending on how far the room temperature is from the desired temperature
•The digital display will read AUTO:M, i.e.
•As the room temperature approaches the desired tem- perature, the appliance will turn down to lower settings
•When the home reaches your set temperature, the appli- ance will go into the shutdown cycle
Manual Mode
•Set the heat output setting from the main screen
•The right bottom button will read HEAT OUTPUT
•You can operate the appliance from any of the 5 levels
•On the lowest level (MAN: L) the appliance will stay on longer, burn less fuel per hour, and will take longer to bring the home up to your desired temperature
•On the highest setting (MAN:H) the appliance will burn more fuel per hour, and bring your home up to tempera- ture more quickly
•In Manual mode the heat output does not change but will stay at the setting you chose until the comfort level is reached (meaning the thermostat has been satisfi ed). Turn to OFF to stop operation.
4.Shutdown Cycle
Once your home has reached your set temperature:
•Appliance will stop feeding fuel and allow the fi re to dimin- ish
•Convection blower will continue to run until the appliance cools to appropriate temperature
•Appliance will begin the
If your appliance is running and the
•The fl oor of the fi repot will open and dump the ash into the ash pan
•It takes approximately 2 minutes to complete the auto- clean cycle
•The fl oor will then shut, and if the thermostat is still call- ing for heat, the fi re will start again
•During this
Additional Screen Messages:
READY It is telling you that the home is up to temperature and doesn’t need any heat.
-- - - - The screen will show 5 dashes when the wall control and the control board are NOT communicating with each other. Check that the wiring on the thermostat is prop- erly connected.
MAINTENANCE BURN This indicates the appliance is operating on battery backup, prior to the
OFF The AUTO/MANUAL SETTING screen has been set to OFF. Set the appliance to OFF when performing periodic maintenance to prevent an unexpected startup.
BLANK SCREEN The ON/OFF switch may in OFF posi- tion. Turn to ON position.
CAUTION
Tested and approved for wood pellets, shelled fi eld corn, wheat and black oil sunfl ower seeds. Burning of any other type of fuel voids your warranty.
December 6, 2011 | Page 11 |