Quantum DLT VS80 manual Setting the Scsi ID, Tabletop Tape Drive Rear Panel Layout

Chapter 3: DLT VS80 Installation

3.2.2Setting the SCSI ID

All SCSI devices attached to the server or workstation must have a unique SCSI ID. Check the SCSI IDs on all other devices on the selected server or workstation, including the SCSI host bus adapter, and select an unused SCSI ID for your tape drive. The factory default SCSI ID for this tape drive is 5, as shown in Figure 3-1. If the tape drive’s factory default SCSI ID is not already in use by another device on the same SCSI bus, you do not need to change the SCSI ID.

68-pin high-density SCSI connectors

5

SCSI ID switch

On

Off

Power switch

Power

cable connector

Figure 3-1.Tabletop Tape Drive Rear Panel Layout

NOTE: If the tabletop tape drive is attached to a narrow SCSI bus, only IDs 0 through 7 are valid. If it is a wide SCSI bus, then you can use IDs 0 through 15.

3-4 May 2004 001596-01 Rev A07