DLT VS80 Tape Drive Installation and Operations Guide

3.3.2Configuring Your Internal Tape Drive

The following sections explain how to configure your internal tape drive.

Setting the SCSI ID

All SCSI devices that are attached to the server or workstation must have a unique SCSI ID. Check the SCSI IDs on all other devices on the selected server or workstation, including the SCSI host bus adapter, and select an unused SCSI ID for your tape drive. The factory default SCSI ID is 5drive’s factory default SCSI ID is not being used, you do not need to change the SCSI ID.

NOTE: If the tape drive is attached to a narrow SCSI bus, you can only use IDs 0 through 7. If it is a wide SCSI bus, then you can use IDs 0 through 15.

1.Locate the SCSI ID jumpers on the rear panel of the tape drive as shown in Figure 3-6.

68-pin SCSI connector

Power connector

SCSI ID jumpers

Figure 3-6.Back Panel Connections, Internal Tape Drive

2.Use the supplied jumpers to set the desired SCSI ID, as shown in the following table:

Table 3-1.Selecting the SCSI ID

SCSI ID

0

1

2

3

4

5a

6

7

Jumper

Block

SCSI ID

8

9

10

11

12

13

14

15

Jumper

Block

a. Factory default SCSI ID

001596-01 Rev A07

May 2004

3-11

Page 25
Image 25
Quantum DLT VS80 manual Configuring Your Internal Tape Drive, Setting the Scsi ID