Quantum LTO-3 manual Configuring for HP-UX, Hardware/Driver, Configuration

Chapter 6 UNIX Settings

Configuring for HP-UX 11.0

M TCAN_COMPRESS,

40, 5*60, 10*60, 10*60, 3*3600, 512, 256*512,

tpsc_default_dens_count, tpsc_defalt_hwg_dens_names, tpsc_default_alias_dens_names, {0}, 0, 0, 0, 0, (u_char*) 0},

After modifying the configuration file, recompile the kernel with the autoconfig command and reboot the system. If you are replacing an existing storage device with the same SCSI ID remove the device files prior to using the autoconfig command and rebooting the system.

Configuring for HP-UX 11.0

Finding Current	To find currently installed SCSI controllers and devices, use the
Hardware/Driver	command can ioscan–f. This command lists all the system devices and
Configuration	their device names.

Attaching the LTO-3Choose a SCSI address that does not conflict with any already attached

Tape DriveSCSI devices on your SCSI controller. See figure 2 for jumper installation for the LTO-3 internal drive. Attach the LTO-3 Tape Drive and apply power to the drive(s) and the host system. After the boot process completes and you log in as superuser, issue the command:

ioscan –C tape –f.

You should see output similar to:

Class I H/WPath Driver S/WState H/Wtype Description

Tape 7 8/12.6.0 stape Claimed Device CERTANCE ULTRIUM

From the root directory and as superuser, issue the command:

/sbin/insf –C tape.

Then issue the command:

/sbin/mksf –d stape –H x/x.x.x –I y –c 1 –n –u /dev/rmt/zcnb

Where:

64 LTO-3 Tape Drive User’s Guide