Installation Instructions
Jumper Settings
Jumpers are located on the motherboard, they represent, clear CMOS jumper JCC, enable BIOS ProtectEasy function jumper JAV etc. Pin 1 of all jumpers are located on the side with
a thick white line ( Pin1→ 
), refer to the motherboard’s silkscreen. Jumpers with
three pins will be shown as 
to represent pin1 & pin2 connected and 
to represent pin2 & pin3 connected.
BIOS-ProtectEasy Jumper (JAV)
The BIOS of the mainboard is inside the FWH. If the jumper JAV is set as closed, you will be unable to flash the BIOS to the mainboard. However in this status, the system BIOS is protected from being attacked by serious virus such as CIH virus.
Flash Write
Disabled
JAV
Flash Write
Enabled (default)
JAV
Under special conditions, the jumper “JAV” should be set as OPEN. For further details, refer to the “BootEasy” part of appendix.
Setting the jumper JAV as open(default), meanwhile disabling the “Flash Write Protect” item from “Advanced BIOS Features ” in AWARD BIOS CMOS Setup, allows you to flash the BIOS to the Flash ROM.
The DMI (Desktop Management Interface) system information such as the CPU type/speed, memory size, and expansion cards will be detected by the onboard BIOS and stored in the flash ROM. Whenever the system hardware configuration is changed, DMI information will be updated automatically. However, setting jumper JAV as closed makes flashing BIOS and updating DMI information impossible. Therefore, set JAV as open when changing the sys- tem hardware configuration, or the error message “Unknown Flash Type” will be displayed on the screen, and DMI information may not be updated.
Manual for PlatiniX 2 series
