Installation Instructions
Enable Front/Back Panel USB Device Wake-up Function (JFUSB/JUSB)
The mainboard provides the advanced USB device wake-up function. The system can be waked up from its power saving including ACPI S3 by activating USB device. Before using this function, set JFUSB/JUSB with pin1 & pin2 closed. Otherwise, set JFUSB/JUSB with pin2 & pin3 closed for disabling. Furthermore, the item “Wake-Up From S3 by USB”in CMOS Setup should also be set correspondingly to enable or disable this function.
| | 1 | 1 |
| JUSB Disable | 2 | 2 |
| 3 | 3 |
| | JFUSB JUSB |
| Enable | 1 | 1 |
| 2 | 2 |
| (default) |
| 3 | 3 |
JFUSB JUSB
JFUSB
Enable/Disable onboard audio (JSD)
(available on PlatiniX 2-A/-AL, PlatiniX 2I-A/-AL)
If you want to use the on-board audio, set JSD with pin2 & pin3 closed. Otherwise, set JSD with pin1 & pin2 closed for disabling this function.
| Enable | 1 | |
| onboard audio | 2 | JSD |
| (default) | 3 | |
| | |
| Disable | 1 | |
| 2 | JSD |
| onboard audio |
| 3 | |
| | |
Manual for PlatiniX 2 series