Appendix
b.If choosing to install RecoveryEasy on an absolutely clear disk, the utility will delete all the previous partitions.
c.The password is set as default setting “qdiqdi” after installing RecoveryEasy.
1.1CREATE PAR
Function : Creates a new partition.
Limitation : When no disk space remains or 4 partitions already exist, this button is
| disabled. |
Steps | : After pressing the “CREATE PAR” button. |
a. The system will prompt whether users want to create a mirror partition for it or not.
b. If answering “Y”, input the new partition size in Megabyte. Notice that the maximum partition size that can be assigned is half of the left disk space, which is also displayed in the status line. Another half is for the mirror partition. If answering “N”, the whole disk space left can be assigned. See
figure-2 Create Partition
Note:
a. The system will prompt “Insert system floppy, then reset” when the first partition on the first hard disk is created.
b. After using DOS6.xx boot disk to format C partition, the system should be reset in order to access the partition.
c. In Windows system 1,048,576 bytes equal 1 Megabyte, while in RecoveryEasy 1,000,000 bytes equal 1 Megabyte, therefore a smaller size will be displayed in Windows system compared with the size displayed in RecoveryEasy.
1.2 DELETE PAR
Function | : Deletes the last partition and its mirror partition. |
Limitation : When no partition exists, this button is disabled. | |
Steps | : After choosing this function, only the final partition can be deleted in |
| order to keep the continuous disk space. If the warning message is |
| confirmed, the partition will be deleted. By pressing “N” or “ESC” key, |
| the system quits. |
Manual for PlatiniX 2 series
