INSTALLATION

1.Plug the Bigpicture camera’s yellow RCA- type video plug into the yellow RCA-type video jack on the capture card.

2.Plug the camera’s power cord into the power jack located just under the video jack on the capture card.

3.Plug the camera’s 1/8-inch audio output plug into the sound card’s MIC or AUDIO IN jack. Refer to your sound card’s documentation for further information.

4.Go to “Installing the Video Capture Card’s Drivers” on page 11.

Connecting a Camcorder or

Other NTSC Device to Your

Video Capture Card

In addition to the NTSC camera included with your capture card, you can connect any NTSC compliant device to the video capture card. In this manner, you could hook up a camcorder, VCR, laserdisc player, or other NTSC video device. You should consult the device’s manual for specific information about connecting the device to a source other than a television. The device must be NTSC compliant to be used with this product.

If your device is NTSC compliant, you should be able to run an RCA male to RCA male cable from the device’s video out jack to the capture card’s video in (yellow) jack. Please

9

Page 12
Image 12
Radio Shack 3Com Bigpicture operating instructions Installation