Radio Shack 49-2551A owner manual Initializing The Wireless Sensor Transmitters

49-2551AB.fm Page 13 Friday, February 19, 1999 3:41 PM

Note: If you do not hear a chime, press the button beneath the remote control’s label with a pen- cil. Then repeat this step.

6.Leave the console’s switch set to INSTALL to install other accesso- ries.

7.Replace the battery compartment cover.

Note: You can add any combination of Plug ’n Power keychains (Cat. No. 49- 2591) or handheld remote controls (Cat. No. 49-2551T), up to a total of eight.

INITIALIZING THE WIRELESS SENSOR TRANSMITTERS

Follow these steps to initialize each wireless sensor transmitter you plan to use with your system.

1.Lift open the- transmitter’s bat- tery compartment cover. Hold down

TEST, located to the right of the compartment, long enough to fully discharge the sensor (about

3 seconds).

2.Install two AA alkaline batteries in the compartment according to the polarity symbols (+ and –) marked inside.

3.Be sure the console’s INSTALL/ RUN 1/RUN 2 switch is set to

INSTALL.

4.Press TEST on the transmitter for about 1 second. The indicator blinks twice to generate a new code.

Note: The indicator flashes rap- idly during a violation or after you press TEST. When the batteries’ voltage drops below around 2.7V, the indicator flashes twice when TEST is pressed to indicate that the batteries are weak.

13