Radio Shack 49-2551A owner manual Set INSTALL/RUN 1/RUN 2 on the console to Install

49-2551AB.fm Page 23 Friday, February 19, 1999 3:41 PM

•You should not program the con- sole to dial the police directly, unless your local police depart- ment has a special line for emer- gency dialers.

When programming emergency num- bers and/or making test calls to emer- gency numbers:

•Remain on the line and briefly explain to the dispatcher the rea- son for the call.

•Perform such activities in off-peak hours, such as early morning or late evenings.

Notes:

•The security console is intended for use only with residential phone systems.

•You can program a maximum of 16 digits. This allows 10-digit dial- ing (area code plus number) which is now required in some metropolitan areas. For practical purposes, we do not recommend programming a long-distance number.

Follow these steps to store up to four emergency phone numbers.

1.Set the switch on the bottom of the console to TONE or PULSE, based on the type of phone service you have.

2.Set INSTALL/RUN 1/RUN 2 on the console to INSTALL.

3.Press PROG.

4.Enter the first phone number that you want the console to call in the event of a problem.

5.Press MEM.

6.Press 1 to store the phone num- ber in memory location 1.

Press PROG and enter the second phone number; then press MEM and 2. Press PROG and enter the third phone number; then press MEM and 3. Press PROG and enter the fourth phone number; then press MEM and 4.

Notes:

•If you only want to program one phone number, just enter the same number in every memory location.

•If you store only one emer- gency number in all four mem- ory locations, there is a longer delay between each time the console calls the number back.

Repeat Steps 1–6 to change a phone number.

23