Radio Shack 49-2551A owner manual Using The Panic Alarm, Zone Indicators

49-2551AB.fm Page 27 Friday, February 19, 1999 3:41 PM

Notes:

•The supplied motion detector (Cat. No. 49-2589) only operates in the INSTANT mode.

If you want to use the exit/entry delay feature, you can use another motion detector (Cat. No. 61-2614) instead of the one sup- plied with this system. However, the ARM HOME feature might not work.

•You must set the switch inside the wireless sensor transmitter’s bat- tery compartment to MAX in order for it to arm in the delay mode. When set to MIN, the sensor immediately arms, regardless of whether the handheld remote con- trol is set to DELAY or INSTANT.

•The ARM button on the console automatically arms the system in the DELAY mode.

•The keychain remote control only arms the system in the INSTANT mode.

•Other separately purchased remote controls might arm the system only in either the DELAY or INSTANT mode. See the remote control’s owner’s manual.

USING THE PANIC

ALARM

Pressing PANIC on the handheld re- mote control, or ARM and DISARM at the same time on the keychain remote control, causes the console’s alarm to sound, even if the system is not armed.

Note: The telephone dialer does not dial out unless the system is armed.

ZONE INDICATORS

All sensors and motion detectors re- port to the console about every 90 min- utes. If the console does not receive a signal from a sensor within 4 hours, it reports a problem with that sensor by slowly flashing its zone indicator.

The console’s zone status indicators show four conditions for Zones 1–8.

27