4.Press TEST on the back of the motion detector.
The console chimes, and the first available zone indicator lights to show the console has logged in the motion detector.
If you do not hear a chime, press CODE with a pencil, then press TEST again.
5.Looking at the back of the motion detector, set the switch on the left side to 1.
6.Place one of the supplied num- bered stickers on the motion detector to show its zone number.
7.Leave the console’s switch set to INSTALL to install other accesso- ries.
8.Replace the battery compartment cover.
INSTALLING THE LAMP MODULE
When the alarm trips, lamps connect- ed to lamp modules flash on and off for the duration of the alarm. After 4 min- utes (or when you disarm the alarm), the lamps stop flashing and remain on.
If you arm the system with an exit de- lay, lamp modules that are set to the same House and Unit code as the con- sole turn on during the exit countdown time.
You can also control lamp modules set to this code from LIGHT ON and LIGHT OFF on the keychain remote control, or using SECURITY LIGHT on the hand- held remote.
Follow these steps to install a lamp module.
1.Plug a lamp into the supplied lamp module and plug the module into an AC outlet that is on the same electrical circuit as the console.
Be sure the lamp’s on/off switch is on.
2.Set the lamp module’s House and Unit code dials to the same letter as the console and the same number (1, 2, 3, or 4) as the but- ton that will control it.
15
