Radio Shack 49-2551A owner manual You do not hear a chime

49-2551AB.fm Page 33 Friday, February 19, 1999 3:41 PM

Problem			Solution
You do not hear a chime			Check if you can arm the system when INSTALL/
from the console when you			RUN 1/RUN 2 on the console is set to RUN 1 or RUN
press ARM to install a re-			2. If you can, the remote control is already installed
mote.			and no further action is necessary. If not:
			1. Set INSTALL/RUN 1/RUN 2 on the console to
			INSTALL.
			2. Press CODE (located beneath the label on the
			remote control) with a pencil, then press ARM
			again.
You do not hear a chime			With INSTALL/RUN 1/RUN 2 on the console set to
from the console when you			RUN 2, check that the console chimes when you
press TEST to install a wire-			press TEST on the sensor or motion detector. If it
less sensor	transmitter	or	does, the sensor or motion detector is already in-
motion detector.			stalled and no further action is necessary. If not:
			1. Set INSTALL/RUN 1/RUN 2 on the console to
			INSTALL.
			2. Press CODE on the sensor or motion detector
			with a pencil, then press TEST again.
			Note: If the sensor/motion detector is already in-
			stalled, it is installed again into the next available
			zone.
BATTERY	LOW on	the	Install or replace the console’s battery.
console is on.
You lose your remote con-			Purchase a replacement remote control (Cat. No.
trol.			49-2551T or 49-2591), and then completely re-
			install your system using different house and unit
			codes to prevent someone else from using the lost
			remote control.
The system arms or dis-			A neighbor may have a compatible system. Re-
arms by itself.			install the system using a different house code.

33