Radio Shack 49-2551A owner manual The red light on the hand

49-2551AB.fm Page 34 Friday, February 19, 1999 3:41 PM

Problem	Solution
The red light on the hand-	Press the button located beneath the label with a
held remote control stays	pencil and then press ARM. If it still stays on, re-
on during installation.	move the battery, wait a few seconds, then replace
	the battery. Press the button and then ARM again.
The red light on the sensor/	Press CODE, then press TEST on the sensor/mo-
motion detector stays on	tion detector. If it still stays on, remove the battery,
during installation.	wait a few seconds, and then replace the battery.
	Press CODE, then press TEST again.
ARMED flashes.	This indicates that there has been an intrusion. Al-
	so, if a zone indicator is on, this indicates which
	zone was violated. To turn the zone indicator off
	and stop the armed indicator from flashing, press
	the LIGHT ON or OFF button on a remote control. If
	a zone indicator is not on, the violated zone is with-
	in zones 9-16. Press BYPASS on the console to see
	which zone was tripped.
A motion detector causes	Motion detectors sense motion by detecting a
“false alarms.”	change in temperature; therefore, do not place the
	motion detector near an air conditioning or heating
	vent.
	Do not place it in a direct source of bright light, such
	as sunlight.
	It could be detecting a pet’s movements. Place the
	detector at a height of 6 feet, or set the switch on
	the back to 2 so it is less sensitive.
The console does not dial	Check that you have stored a phone number (see
out.	“Setting up Phone Numbers” on page 22).
	Check that the console is armed
The console does not play	Check that you have recorded a message (see
back any message when	“Recording a Voice Message” on page 24).
the phone is answered.

34