TESTING THE SYSTEM
After you have completed all of the quick installation procedures, follow these steps to test the system.
Note: To avoid unnecessarily alarming your neighbors, tell them you are test- ing the system.
1.Set the INSTALL/RUN 1/RUN 2 switch on the console to RUN 2. REC/BUSY lights for 15 seconds.
2.Place each wireless sensor trans- mitter’s magnet next to its mag- netic switch with the arrows pointing toward each other.
3.Place the motion detector on a counter top within 100 feet of the console.
16
4.Move a wireless sensor transmit- ter’s magnet away from the mag- netic switch.
When the system is not armed and set to RUN2, the console emits a chime every time some- one opens a door or window. The system does not chime when it is set to RUN 1.
Replace the magnet next to the magnetic switch.
5.Press ARM on a remote control, and then move the magnet away from the magnetic switch again. The alarm sounds and the lamp connected to the lamp module flashes on and off. Press DISARM to turn off the alarm, and LIGHTS OFF to turn off the lamp. Replace the magnet next to the magnetic switch.
6.Press ARM AWAY on the remote control, then walk across the path of the motion detector’s lens. The alarm sounds and the lamp con- nected to the lamp module flashes on and off. Press DISARM to turn off the alarm. The console chimes twice. Press LIGHTS OFF to turn off the lamp.
