Radio Shack 49-2551A owner manual Initializing The Motion Sensor

49-2551AB.fm Page 14 Friday, February 19, 1999 3:41 PM

5.Stand near the

console and press TEST. The wireless sensor transmitter’s indi- cator blinks.

6.Release TEST.

The console chimes and logs in the newly gen- erated code for the wireless sen- sor transmitter. The first avail- able zone indica- tor on the console lights.

7.Set DELAY inside the wireless sen-

sor transmitter’s battery compart- ment to MIN to protect a window or to MAX to pro- tect a door. Then close the battery compartment’s cover.

8.Place one of the supplied num- bered stickers on the sensor to show its zone number.

9.Leave the console’s switch set to INSTALL to install other accesso- ries.

Repeat Steps 1–8 for additional wireless sensor transmitters.

14

INITIALIZING THE

MOTION SENSOR

1.Press the four dots on the battery compartment cover and slide the cover down to remove it.

2.Install four 1.5V AA alkaline bat- teries inside the motion detector’s battery compartment according to the polarity symbols (+ and –) and replace the cover.

3.Be sure the console’s INSTALL/ RUN 1/RUN 2 switch is set to

INSTALL.