Radio Shack MX-500TM manual See “Programming Punch Through” functions on Page

4.ProgrammingtheMX-500TMtoControlYourComponents

6.Press the button on the MX-500TMyou wish to program. Only the three MAIN, PAGE and FAV buttons cannot be programmed.

7.Press the button on your original remote control that you wish to program onto the MX-500TM. Once the MX-500TMhas received the signal, the MX-500TMwill flash “Good” on the LCD screen, indicating it learned the code correctly.

(Please do Step #6 within 20 seconds of Step #5, otherwise the remote will revert to the SETUP menu, and then after a period of time, it will go back to the MAIN device page.)

If it flashes “Fail”, repeat from Step 4 until it learns successfully.

8.Return to Step #3 until you have programmed all of the buttons that you require.

9.Once you complete the programming and wish to exit the LEARNING mode, press the MAIN button. Exit from the SET UP mode by pressing the MAIN button once again.

Tip: Learning to VOL, CH and Transport buttons: If you are having problems learning to the Volume, Channel and Transport buttons, it may be that you have previously assigned a “Punch Through” from another device to that device. To remove a Punch Through, just punch through the device to itself. For example, to erase a punch through from a TV to an Audio Device, just punch through the TV to the TV.

(See “Programming Punch Through” functions on Page 32.)

21