Radio Shack MX-500TM manual Programming The Ten Device Buttons

4.ProgrammingtheMX-500TMtoControlYourComponents

2. Programming The Ten Device Buttons

This will program ONE learned code onto the Device button, so that when you select that Device, it will send out the learned signal as it changes to that Device's function pages.

1.Go to the SETUP mode by pressing both the MAIN and ENT buttons simultaneously for three seconds.

2.Press the LEARN button next to the LCD screen.

3.Important: Press the PAGE button.

4.Place your original remote control head to head with the MX-500TMabout 2 inches apart on a flat surface.

5.Select any of the ten device buttons you wish to program on the MX-500TM. Press the button on your original remote control you wish to program into the Device button you have chosen on the MX-500TM. Once the MX-500TMhas received the signal, the MX-500TMwill flash “Good” on the LCD screen, indicating it learned the code correctly. If it flashes “Fail”, repeat from Step 4 until it learns successfully. (Please enter the code signal within 20 seconds of programming.)

6.Return to Step #5 until you have programmed all of the Device buttons that you require.

22