Chapter 3: Installation

19

Although this provides a useful alternative method for securing your instrument, it is only suitable for use in positions where the instrument will not be exposed to water.

To bracket mount your ST60 instrument, do so in accordance with the Control Unit Mounting Bracket Instruction Sheet.

Fitting transducers

If you are fitting an ST60 Wind instrument and wish to use it as a master instrument, you must also fit a wind transducer.

Wind vane

Rotavecta

Typical transducers

D6954-1

 

Note: An ST60 Close Hauled Wind instrument can only be used as a repeater instrument, so a directly-connected transducer is not required.

Typical windvane installation

Note: Do NOT remove the connector cap from the wind vane base connector, until you are ready to fit the wind vane arm.

The wind vane base must be horizontal. If necessary, make up a suitable packing piece to provide a horizontal mounting surface.

Packing piece, if required

D6868-2

Page 31
Image 31
Raymarine ST60 manual Fitting transducers, Typical windvane installation