iv | ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook | |
2.2 | Troubleshooting | 8 |
| Preliminary procedures | 8 |
| Fixing faults | 8 |
| Technical support | 9 |
| World wide web | 9 |
| Telephone help line | 9 |
| Help us to help you | 9 |
Chapter 3: Installation | 11 | |
3.1 | Planning your installation | 11 |
| Site requirements | 11 |
| Transducers | 11 |
| Instrument | 12 |
| EMC installation guidelines | 13 |
| Suppression Ferrites | 14 |
| Connections to Other Equipment | 14 |
3.2 | Procedure | 14 |
| Unpacking | 14 |
| Fitting the instruments | 15 |
| Surface mounting | 15 |
| Flush mounting | 16 |
| Fitting the | 16 |
| Flush mounting procedure | 17 |
| Bracket Mounting | 18 |
| Fitting transducers | 19 |
| Typical windvane installation | 19 |
| Rotavecta | 21 |
| Running transducer cable | 22 |
| General | 22 |
| From masthead | 23 |
| Connecting the instruments | 24 |
| Types of connection | 24 |
| Signal connections | 24 |
| Power supply connections | 25 |
| SeaTalk systems | 25 |
| Stand alone instruments | 26 |
Chapter 4: Calibration | 27 | |
4.1 | Introduction | 27 |
| EMC conformance | 27 |
4.2 | User calibration | 27 |
| Linearizing and aligning the wind transducer | 27 |
| Leaving User calibration | 28 |
