Raymarine ST60 manual Flush mounting procedure, Fitting the low profile bezel

Chapter 3: Installation 17

4.Snap the low-profile bezel (8) in position over the instrument, so that the rub- ber keys are correctly located in the holes on the bezel.

CAUTION:

It is essential that only screws of the correct size are used to secure the instrument to the bezel. Failure to observe this caution could result in damage to both the instrument and the bezel.

5.Using the four, self-tapping screws (9) provided, secure the instrument and bezel together. Fit the screws from the rear of the instrument and tighten them sufficiently to secure the instrument and bezel together. DO NOT OVER-

TIGHTEN.

8	7	9
Fitting the low profile bezel		D4356-2

Flush mounting procedure

Flush mount your instrument (see the Flush mounting illustration) as follows:

1.Assemble the ST60 instrument and low-profile bezel as described under Fit- ting the low-profile bezel .

2.Ensure that:

•The panel on which you intend to mount the instrument is between 0.12 in (3 mm) and 0.78 in (20 mm) thickness.

•The selected location is clean, smooth and flat.