Chapter 4: Calibration | 29 |
4.3 Intermediate calibration
The intermediate calibration screens enable you to check:
•The instrument software version number. This information is normally required if you request parts or repairs.
•The instrument status - either r0 (master) or r1 (repeater).
To use the Intermediate calibration screens, hold down the disp and true/app keys for approximately 4 seconds.
Hold down |
| and | true | for approximately 4 seconds | |
disp | app | ||||
|
|
|
Software version
CAL
TRUE | APP |
disp |
|
Instrument |
|
status |
|
TRUE | APP |
Intermediate calibration |
Leaving Intermediate calibration
Hold down the disp and true/app keys for 2 seconds to exit Intermediate calibration and resume normal operation.
4.4 Dealer calibration
The Dealer calibration procedures enable the following parameters to be set:
•User calibration on/off.
•Wind angle and speed response.
•Velocity Made Good (VMG) response.
•Wind speed calibration.
•Boat show mode on/off.
