Raymarine ST60 manual Stand alone instruments

26	ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook
	Red
	5 A fused,	1	2	3	4
	12 V dc supply
	(typically provided
	by autopilot)
	Screen
					Instruments
	Red				5 to 16
	Screen	20	19	18	17
	SeaTalk power connections				D4311-1

Stand alone instruments

Stand-alone instruments are not connected to SeaTalk and therefore need to be connected to an alternative 12 V power source. Power cables are available in 2 m and 9 m lengths.

To fit a power cable:

1.Ensure the intended power source is switched off.

2.Run the power cable from the instrument to a suitable 12 V dc power source.

3.If the cable has not already been trimmed at the power supply end:

i.Cut the cable to length and trim back an appropriate amount of the outer sheath.

ii.Cut back and insulate the yellow wire.

4.Connect the screen to the power supply 0 V terminal.

5.Connect the red wire via a 3 A circuit breaker to the power supply +12 V ter- minal.

6.Insert the power cable connector into one of the SeaTalk connectors at the rear of the instrument.

12 V dc

supply

3 A over-current

circuit breaker

Red

Screen

Power connections for stand-alone instrument D4310-4