Chapter 3: Installation | 21 |
Fixing | Base |
screws |
|
| Connector cap |
| Arm |
| Locking ring |
| |
Rotavecta |
|
The Rotavecta can be clamped to a 0.9 in (23 mm) or a 1 in (25 mm) rail by means of an integral clamp. To fit a Rotavecta:
1.Dismantle the integral clamp, and ensure the pointed end of the grub screw does not protrude through the top of the lower clamp section.
2.If the rail is 1 in (25 mm) diameter, set aside the two spacers. If the rail is between 0.9 in (23 mm) and 1 in (25 mm) diameter, place the spacers in the
lower part of the clamp.
[
Clamp screws
| Rail mount disc |
Spacers |
|
| Grub screw |
Rotavecta rail clamp |
3.Offer up the lower part of the clamp (and spacers if used) underneath the rail.
4.Place the rail mount disc on the upper side of the rail and place the upper part of the Rotavecta on top of this, so that all the screw holes are in alignment.
