Raypak 207A, 406A, 206A, 407A, 337A Remote Control Wiring, Wire Remote Control On-Off, P8 Connector

Models: 266A 267A 207A 336A 337A 407A 206A 406A

1 55
Download 55 pages 6.49 Kb
Page 37
Image 37
BLK/ORN - To Pool (COMM)
ORN/BLK - To Spa (COMM) BLU - 24VAC
P8 Connector

REMOTE CONTROL WIRING

Important Installation Notes for Remote or External Wiring Configuration

Remote wiring must be run in a separate conduit.

Remote wiring must not be run parallel to high voltage lines.

For runs of under 30 feet, remote wiring should have stranded conductors with a minimum of 22 AWG, 600V, cable twisting 1.5 to 2.5 in. lay and jacketed.

For runs over 30 feet, the conductors should be a minimum of 20 AWG, 600V, cable twisting 1.5 to 2.5 inch lay that is shielded and jacketed.

Maximum cable length is 200 feet.

For both two- and three-wire remote systems, the provided 7-pin wiring connector must be utilized. Please refer to the wiring instructions.

Note: The remote wires must be connected to the 7-pin connector before the connector is plugged into the board.

2-Wire Remote Control (On-Off)

This application assumes that only one heating function (pool or spa) is required.

Wire Nut - BLK/ORN

To Pool (COMM)

ORN/BLK - To Spa (COMM)

BLU - 24VAC

P8 Connector

1.Turn on power to the heater.

2.For a 2-Wire Remote Control from a remote without its own sensor, push the mode button to the “POOL” or “SPA” mode and set the desired setpoint (eg. 102 °F for spa).

3.For a 2-Wire Remote Control from a remote with its own sensor, push the mode button “POOL” or “SPA” mode and set the temperature to the highest setting available on the control. The actual setpoint will be controlled by the remote control.

4.Turn the mode button to "OFF" and remove power from the heater.

5.On the "Remote Interface Harness", connect the BLUE wire to one side of the "REMOTE" switch and connect the other side to either the ORANGE/BLACK wire for "SPA" operation or the BLACK/ORANGE wire for "POOL" operation.

6.Attach wire nut on unused wire to the "Remote Interface Harness."

7.Install the "7-Pin Remote Interface Harness" to the

P8 connector and turn power “On” to the heater.

See instructions on previous page to activate the remote control.

3-Wire Remote Control Using Three-Position Switch (Pool-Off-Spa, or Low-Off-High)

This application assumes that both heating functions (pool and spa) are required.

1. Turn on power to the heater.

2. Push the mode button to the "POOL" or "SPA" mode and set the desired temperature for each (eg. 80°F for Pool and 102°F for Spa).

3. Turn the mode button to "OFF" and remove power from the heater.

4. On the "Remote Interface Harness" connect the BLUE wire to one side of the "REMOTE" switch and connect the ORANGE/BLACK wire for "SPA" operation and the BLACK/ORANGE wire for the "POOL" operation.

5. Install the "Remote Interface Harness" to the P8 connector and turn power "ON" to the heater.

See instructions on previous page to activate the remote control.

37

Page 37
Image 37
Raypak 207A, 406A, 206A, 407A, 337A, 336A, 267A, 266A Remote Control Wiring, Wire Remote Control On-Off, P8 Connector