RCA CC6251, CC6271 Date and Time Display, Install the Clock Lithium Cell, To Remove Lithium Cell

Date and Time Display

Install the Clock Lithium Cell

The clock cell indicator flashes for a few seconds in the viewfinder when you turn on the camcorder if the cell is not installed or needs replacing.

Insert Object Here to Remove Cell

Clock Cell

(+ Side Facing Out)

Clock Cell

Compartment

VCR

POWER OFF CAMERA

1.Make sure camcorder is turned off, and remove any power supply attached to the camcorder.

2.Press release tab of clock cell compartment cover and open the compartment.

3.Insert the clock cell with the “+” terminal facing out, and press it in.

4.Close the compartment cover. It clicks into place.

To Remove Lithium Cell

To remove battery, insert a pointed nonmetallic object between battery and compartment and lift.

Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.

Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.

The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.

Never use metallic tweezers to hold the cell, and never short the + and – sides of the cell.

17