RCA Pro809 specifications Installation, To Edit Insert From a TV or Another VCR

Edit Insert (continued)

Installation

1Attach the audio/video cable’s white plug to the AUDIO OUT jack of the TV (or VCR).

Note: If your TV (or VCR) has stereo AUDIO jacks, attach the white plug to the one labeled MONO. If one is not labeled MONO, you may need a Y-adapter, such as AH25 shown on page 3, to hear both channels.

2Attach the audio/video cable’s yellow plug to the VIDEO OUT jack on the TV (or VCR).

3Attach the yellow plug on the other end of the audio/video cable to the VIDEO jack and the white plug to the AUDIO jack located behind the small cover on the side of the camcorder.

4Place the A/V (audio/video) IN/OUT switch to IN.

To Edit Insert From a TV or Another VCR

The source for audio and video during edit insert from a TV or VCR is the signal coming through the audio and video plugs of the audio/video cable.

If you connect only the video plug of the audio/video cable to a TV or VCR, you will have no sound on the dubbed portion.

If you connect only the audio plug of the audio/video input cable to the TV or VCR, the camcorder will not dub.

1.Connect the camcorder to the TV or VCR as shown.

2.Place camcorder’s CAMERA/OFF/ VCR switch in VCR.

3.Insert the tape you want to insert new audio and video on in the camcorder.

4.Look into the viewfinder and use 6/FADE (PLAY on remote),

55/EDIT – and 66/EDIT +(55 REW/SCAN and 55 F.FWD/SCAN on remote) to locate the place on the tape where you want edit insert to end.

5.Make sure DATE/TIME/NORMAL/ TITLE switch is in NORMAL, and press RESET to reset the time counter to 0:00:00.

6.Use 6/FADE (PLAY on remote), then

55/EDIT – (55 REW/SCAN on remote) , to locate the place on the

tape where you want edit insert to begin, and press /D•S•E (PAUSE on remote) to place the camcorder in play pause where you want to begin dubbing.

7.Press VCR REC, to place camcorder in record pause.

8.Press Z/MEMORY to turn on zero memory and store the insert ending point in memory. MEM flashes under the time counter.

9.Start the other component playing. Press /D•S•E (PAUSE on remote) to start dubbing. The camcorder will stop recording at the zero memory point.

Note: Zero memory is cancelled when insert recording is complete.

47