INSTALLATION
INSTALLATION
VENTING ARRANGEMENTS
HORIZONTAL TERMINATION (FLEX)
Regency® Direct Vent System
These venting systems, in combination with the P40 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in "Exterior Vent Termination Requirements" section.
Regency® Direct Vent (Flex) System Termination Kit (Part#
1)8" dia. fl exible liner (4 ft. length)
2)5" dia. fl exible liner (4 ft. length)
3)spring spacers (4)
4)thimble
5)AstroCap XL termination cap (1)
6)screws (12)
7)tube of Mill Pac (1)
8)plated screws (8)
9)screws #8 x
10)vinyl siding standoff
Iflongerrunsareneeded,theRegency® Direct Vent system (Flex) Part#
1)8" dia. fl exible liner (10 ft. length)
2)5" dia. fl exible liner (10 ft. length)
3)spring spacers (7)
4)thimble (2)
5)AstroCap XL termination cap (1)
6)screws (12)
7)tube of Mill Pac (1)
8)plated screws (8)
9)screws #8 x
10)vinyl siding standoff
AstroCap XL
(Part# 946-623/P)
Wall Thimble
(required in Canada only)
| Vinyl Siding | |
| Standoff | |
5” dia. flue pipe |
| |
8" dia. | spring spacer | |
Flue pipe | ||
|
Notes:
1)Liner sections should be continuous without any joints or seams.
2)Only Flex pipe purchased from FPI may be used for Flex installations.
3)Horizontal vent must be supported every 3 feet. (For 10' flex kit
14 | Regency® P40 Direct Vent Gas Fireplace |