OPERATION
OPERATION
When attaching the Implement input driveline to the Tractor PTO, it is important that the connecting yoke spring activated locking collar slides freely and the locking balls are seated securely in the groove on the Tractor PTO shaft. Push and pull the driveline back and forth several times to ensure it is securely attached. A driveline not attached correctly to the Tractor PTO shaft could come loose and result in personal injury and damage to the Implement.
7.1 Driveline Length Check
Before operating the Implement, check to make sure the Implement input driveline will not bottom out or become disengaged. Bottoming out occurs when the inner shaft penetrates the outer housing until the assembly becomes
Raise mower and watch the Driveline as it approaches the colored tape. If the distance between colored tape and the end of the outer shield tube is 2" or less, Drive Tubes should be shortened per figure
Always maintain 2" clearance when operated in shortest working position. Shorten inner and outer guard tubes equally. Shorten inner and outer sliding profiles by the same amount that the shield tubes were shortened. Round off all sharp edges and remove burrs. Grease sliding profiles. Figure Op- 11_A.
Lower mower to lowest position possible. Turn off the Tractor and apply Parking Brake. Apply a second piece of colored tape to the Inner Shield 1/ 8” from the end of the Outer Shield. Disconnect Driveline from Tractor and then separate the two Driveline halves. Check the distance from the new piece of colored tape to the end of the inner profile. If distance is less than 8" consult dealer to obtain a longer Driveline. Driveline Tube engagement must always exceed 8".
DB150 07/11 | Operation Section |
© 2011 Alamo Group Inc.
