MAINTENANCE

MAINTENANCE

6.Note the orientation of all grease fittings before removing any yokes or crosses. Remove the end yoke from the center housing.

7.Repeat steps 2 - 6 to remove the shaft yoke and cross from the center housing.

8.Use the hammer and the driver to remove the two bearing cups from the center housing. Figure MntP-R-0133

9.Remove the snap rings from the end yoke and the shaft yoke. (Refer to Step2)

10.Set the end yoke on the vise so the trunnions of the cross are supported by the jaws of the vise. Hit the end yoke to force the bearing cup out of the end yoke. The bearing cup will only be forced part way out of the end yoke. Note: When hitting the end yoke NEVER hit the area around the hole in ear. Distortion of the hole will make removal of the bearing cup difficult. Figure MntP-R- 0134

11.Repeat step 10 to push the other bearing cup part way out of the end yoke.

12.Fasten one of the bearing cups in the vise. Make sure the jaws of the vise are as close to the end yoke as possible. Hit the end yoke to drive the yoke up off the bearing cup, similar to Step 5.

13.Repeat Step 12 to remove the other bearing cup from the end yoke.

14.The opening between the ears on the end yoke is wider on one side. Remove the cross from the side that has the wider opening.

15.Repeat Steps 10 - 14 to remove the cross from the shaft yoke. Be careful not to hit the grease fitting in the shaft yoke.

FN20/FN14 NITRO 02/10

Maintenance Section 5-12

© 2010 Alamo Group Inc.

Page 152
Image 152
Rhino Mounts FN14, FN20 manual Maintenance