OPERATION

OPERATION

7.3 Lowest Cutting Height

NOTE: Only operate in the lower position when you are mowing in an agricultural application, be sure there are no bystanders, passerby or livestock with in 300 feet. .

To achieve the lowest possible cutting height, raise the side skirt from the upper set of holes to the lower set of holes shown in Figure Op-245

Never crawl under a raised Implement supported solely by the Tractor 3-Point hitch. Release of the control lever or mechanical failure will result in the Implement falling and possible injury or death. Always securely block up the Implement before crawling underneath to perform repairs and service. (S3PT-19)

Also raise both skid shoes from the lower holes to the upper holes as shown in Figure Op-246. NOTE: Change height back to normal position before operating or mowing on roadside, ditches or greenbelts

FN20/FN14 NITRO 02/10

Operation Section 4-14

© 2010 Alamo Group Inc.

Page 104
Image 104
Rhino Mounts FN14, FN20 manual Lowest Cutting Height