OPERATION

3. TRACTOR REQUIREMENTS

The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take Off (PTO) at the mower’s rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the mower with a tractor that does not meet the following requirements may cause tractor or mower damage and be a potential danger to the operator and passersby.

Tractor Requirements and Capabilities

ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.

Tractor Safety Devices

Slow Moving Vehicle (SMV) emblem, lighting,

 

 

PTO master shield

Tractor Horsepower -Minimum

NITRO FL20 80HP; NITRO FL14 80HP

Drawbar

14” length for 540 RPM unit; 16” or 20” length for 1000 RPM unit,

 

mower equipped with Pintle Hook (Optional Equipment) drawbar length must be modified (see 3.4 Draw-

 

bar), rated to carry weight of mower, safety chain attachment point (See Chart Below)

Tongue Weight

3100 lbs.

 

Hydraulics

Minimum of 1 hydraulic port (extra 3-spool valve required). Minimum

 

2 ports, 3 ports recommended if additional,3-spool control valve is not used.

Front End Weights

As needed to maintain 20% weight on front axle

Power Take Off 540 RPM 6-spline or 1000 RPM 21-spline, 1-3/8” diameter output shaft depending on mower

operating speed.

 

 

 

 

Drawbar

Min.

 

 

Category

Tractor HP

 

 

II

80

 

 

III

90

For other PTO & Drawbar Category Combinations see your Tractor specifications.

3.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened. Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an authorized dealer. OPS-U- 0003

Operate this Equipment only with a Tractor equipped with an approved roll-

over-protective system (ROPS). Always wear seat belts. Serious injury or even death could result from falling off the tractor--particularly during a turnover when the operator could be pinned under the ROPS. (SG-7)

FN20/FN14 NITRO 02/10

Operation Section 4-5

© 2010 Alamo Group Inc.

OPERATION

Page 95
Image 95
Rhino Mounts FN20, FN14 manual Tractor Requirements and Capabilities, Rops and Seat Belt