MAINTENANCE
Return the bolts to their original position as described in (b) above.
NOTE: If machine sits outside longer than 30 days and is exposed to rain and humid air, the Torque Limiter should be removed from machine and stored in a dry area. Torque Limiter facings will soak up moisture and cause the metal plates to rust badly. When this occurs, the
TORQUE LIMITER REPAIR PROCEDURE
6.Remove two bolts from top cover plate which holds shield bracket to gear box.
7.Remove locknuts #11 from bolts #12.
8.Remove cotter pin #13, castle nut #14, and washer #15. NOTE: It may be necessary to rotate yoke to remove cotter pin. Remove driveline yoke from shaft.
9.Loosen three bolts #8 until large nut #7 maybe removed from hub #1.
10.Remove all parts from hub #1.
11.Clean or sand outer plates #2 and center plate #4 to remove rust or burned lining material from plates.
12.Reassemble clutch as shown in
13.Install driveline yoke onto shaft and install four bolts through yoke spacers #10 and center plate #4. Install locknuts and tighten.
14.Rotate yoke and center plate so that cotter pin #13 can be installed.
15.Tighten large nut #7 as much as possible by hand. NOTE: Make sure all springs #5 are centered on guide ring #6.
FN20/FN14 NITRO 02/10 | Maintenance Section |
© 2010 Alamo Group Inc.
