Ricoh 3030 appendix Adjust the paper guides to the pa- per size, Select the paper size

Getting Started

BAdjust the paper guides to the pa- per size.

Important

1 ❒ If the paper guides are not flush against the paper, skewing and misfeeds might occur.

❒Fan the paper to get air between the sheets to avoid a multi-sheet feed.

❒When setting an OHP transpar- ency, make sure that its front and back sides are properly po- sitioned.

D

AJO008S

1.Extender

2.Paper guides

3.Paper guide release lever

Note

❒Before loading paper, unlock the paper guides by pushing up the paper guide release lever.

❒To lock the paper guides, push down the paper guide release lever. The machine then selects the bypass tray automatically.

C Gently insert paper face up into the bypass tray until the beeper sounds.

Note

❒The beeper will not sound if it is turned off. Gently insert paper until it stops.

❒Do not stack paper over the lim- it mark, otherwise a skewed im- age or misfeeds might occur.

❒Open out the extender to sup-

port paper sizes larger than A4 L, 81/2 υ11 L.

❒Select paper type when printing onto OHP transparencies or thick paper (over 127.9 g/m2). For details, see p.16 “Setting Thick Paper or OHP Transpar- encies”.

Select the paper size.

Note

❒The following procedures are not required if you select [Driver / Command] from [Bypass Tray Setting Priority] in [System] of [Printer Features] (see p.128 “Sys- tem”). In that case, set paper size using the printer driver.

❒If you select [Machine Settings] from [Bypass Tray Setting Priority] in [System] of [Printer Features]

(see p.128 “System”), the set- tings made using the control panel have priority over the printer driver settings.

❒If the printer driver is not used, select [Machine Settings] from [Bypass Tray Setting Priority] in [System] of [Printer Features] (see p.128 “System”). Set the paper size using the control panel.

❒Thick paper and OHP transpar- encies are delivered face up on the top of the preceding page; therefore, the prints need to be rearranged into the correct or- der. To avoid this, select [Re- verse order print:] in the RPCS printer driver settings to deliver the prints in the correct page or- der.

14