Paper and Other Media
Additional cautions | • | Print speed for OHP transparencies is slower than for plain pa- |
|
| per. |
| • | Due to switching modes, the machine will be on standby for |
|
| thirty or forty seconds after the job was received. |
|
|
|
Envelopes |
|
|
|
| |
|
| |
Printer setup | Press [Paper Input] menu, [Paper Type], and then press [Thick Paper] | |
| on the control panel. | |
| ❒ The paper type selected using the printer driver overrides that | |
|
| selected using the control panel. |
|
| |
Printer driver setup | Click [Thick] in the [Type:] list. | |
|
| |
Enabled paper feeding tray | Any input tray can be used. | |
| ❒ Make sure paper is not stacked higher than the upper limit | |
|
| mark (T) inside the tray. Make sure paper is not stacked higher |
|
| than the paper guides inside the bypass tray. |
|
| |
Not possible | ||
|
| |
Additional cautions | • Check the print side is facing up. | |
| • Check there is no air in the envelopes before loading. | |
| • For better print quality, we recommend the right, left, top, and | |
|
| bottom print margins to be at least 20 mm (0.8”) each. |
| • Load only one size and type of envelope at a time. | |
| • Before loading envelopes, flatten their leading edges (the edge | |
|
| going into the printer) by running a pencil or ruler across them. |
| • Some kinds of envelope might cause misfeeds, wrinkles or | |
|
| print poorly. |
| • Print quality on envelopes may be uneven if parts of an enve- | |
|
| lope have differing thicknesses. Print one or two envelopes to |
|
| check print quality. |
|
|
|
|
|
|
Paper not supported by this printer
Avoid using the following paper as they are not supported by this printer.•Paper meant for an12