Troubleshooting
Messages/Second | Description | Solution | |
messages |
|
| |
|
|
| |
Hardware Problem | There is a problem with the par- | If you use the parallel I/F, replace the | |
Parallel I/F | allel interface. | interface cable that caused the error. | |
| If the message appears again, contact | ||
|
| ||
|
| your sales or service representative. | |
|
|
| |
Hardware Problem | There is a problem related to | Turn the power off, and then on. If the | |
USB | the Universal Serial Bus Con- | message appears again, contact your | |
nection and Hardware. | sales or service representative. | ||
| |||
|
|
| |
Hardware Problem | An error was detected in the | Turn the power off, and then on. Re- | |
Wireless Board | IEEE 802.11b interface unit or | move and | |
the Bluetooth interface unit. | interface unit or the Bluetooth inter- | ||
| |||
|
| face unit correctly. | |
|
| If the message appears again, contact | |
|
| your sales or service representative. | |
|
| See “ Attaching 802.11b Interface Unit | |
|
| Type F ” or “Attaching Bluetooth Inter- | |
|
| face Unit Type C ”, Setup Guide. | |
|
|
| |
Hardware Problem | The IEEE 802.11b interface | Turn the power off, and then on. Re- | |
Wireless Card | unit or the Bluetooth interface | move and | |
unit could not be detected when | interface unit or the Bluetooth inter- | ||
| |||
| the power was turned on. The | face unit correctly. | |
| IEEE 802.11b interface card or | If the message appears again, contact | |
| the Bluetooth interface card | ||
| your sales or service representative. | ||
| was removed after the power | ||
| See “ Attaching 802.11b Interface Unit | ||
| was turned on. An error was | ||
| Type F ” or “Attaching Bluetooth Inter- | ||
| detected in the IEEE 802.11b | ||
| face Unit Type C ”, Setup Guide. | ||
| interface card or the Bluetooth | ||
|
| ||
| interface card. |
| |
|
|
| |
HDD Full | The maximum HDD area size | Delete the disused form/font types. | |
| for form/font has been exceed- |
| |
| ed. |
| |
|
|
| |
| The optional Hard Disk Drive is | Delete any unnecessary stored files. | |
| full. The sample print job or |
| |
| locked print job to be sent from |
| |
| the computer is too large to |
| |
| store. |
| |
|
|
| |
HDD not Installed | You cannot print the sample | Install the Hard Disk Drive. | |
| print and the locked print jobs, | See “Attaching Hard Disk Drive Type | |
| because the optional Hard Disk | ||
| 2600”, Setup Guide. | ||
| Drive is not installed. | ||
|
| ||
|
|
| |
Hex Dump Mode | The printer is in Hex Dump | No action required. | |
| Mode. |
| |
|
|
| |
Invalid Data | The printer has received irregu- | Turn the power off, and then on. If the | |
Power Off On | lar data. | message appears again, contact your | |
| sales or service representative. | ||
|
| ||
|
|
|
78