Troubleshooting
Error & Status Messages on the Control Panel
This section explains what the messages that appear on the control panel mean and what to do when a particular message appears.
❖Messages (in alphabetical order)
Messages/Second | Description | Solution | |
messages |
|
| |
|
|
| |
Call Service: EC | A communication error sent | Turn the power off, and then on. If the | |
Power Off On | from the engine to the controller | message appears again, call your | |
has occurred in the printer. | sales or service representative. | ||
/ If Error Reoccur | |||
|
| ||
Call Service |
|
| |
|
|
| |
Cannot check | An attempt to check the radio | To check the radio signal , select In- | |
Signal in Ad hoc | signal was made while the | frastructure in the communication | |
communication mode was set | mode settings. | ||
| |||
| to [802.11 Ad hoc] in the interface |
| |
| settings. |
| |
|
|
| |
Change Setting | The paper size and type setting | Load paper of the selected size in the | |
Tray # | in the tray differs from that of | tray, and then change the paper size | |
actual paper size and type in | setting with the control panel. Or, | ||
/ Paper Size: | |||
the tray. | press {Form Feed}, and then select the | ||
Paper Type: | |||
#: tray number | tray using the control panel. Or, press | ||
| {Job Reset} to cancel the print job. | ||
|
| ||
|
| You can make to setting to print disre- | |
|
| garding the error message. | |
|
|
| |
Close Duplex | The cover of the optional du- | Close the cover of the optional Duplex | |
Unit Cover | plex unit is open. | Unit. | |
|
| ||
|
|
| |
Close | The front cover is open. | Close the front cover by pressing the | |
Front Cover |
| left and right side indentations. | |
|
| ||
|
|
| |
Close Rear/Paper | The paper exit cover or the rear | Close the paper exit cover or the rear | |
Exit Cover | cover is open. | cover. | |
|
| ||
|
|
| |
DHCP assigned | An attempt to change the IP ad- | Make the change after setting DHCP | |
Cannot change | dress, subnet mask or gateway | to [Off]. | |
address was made while DHCP |
| ||
|
| ||
| was set to [On]. |
| |
|
|
| |
Energy Save Mode | The printer is in Energy Saver | No action required. | |
| mode. |
| |
|
|
| |
Error: Enter 5 | An ID with an invalid number of | Enter the correct number of digits for | |
or 13 characters | digits was entered for the WEP | the WEP key. | |
key. |
| ||
|
| ||
|
|
|
G1168611A_1.10 | Copyright © 2004, 2005 75 |