Placing Originals

Placing Originals in the ADF

Settings should be made in the following situations:

When placing custom size originals:

p.20 “Placing custom size origi-

2 nals”

Note

Do not stack originals over the lim- it mark on the side fence of the ADF.

The last page should be on the bot- tom.

Do not cover the sensors with your hands, or place objects on them. Doing so could cause the size to be detected incorrectly, or the paper misfeed error message to appear. Also, do not place anything on the cover, as this too could cause a malfunction.

ADF

AAI036S

1.Sensor

A Set the document guide to the original size.

B Align the edges of the originals and place them in the ADF with the side to be copied facing up.

AAI026S

1.Limit mark

2.Document guide

Note

Straighten curls in the originals before placing them in the ADF.

To prevent multiple sheets feed- ing in at once, fan the originals before placing them in the ADF.

Set the original squarely.

Placing custom size originals

When placing custom size originals in the ADF, specify the size of the origi- nals.

Note

Paper that has a vertical length of 105–297 mm (4.2"–11.6") and a hor- izontal length of 128–1260 mm (5.1"–49.6") can be placed with this function.

A Select the paper tray using {U}or {T}, and then press the {#}key.

20