Turning the power off
1Press the ON/STANDBY button.
When the setting of beep sound is [On], the projector beeps, and a message appears on the screen, confirming that you wish to shut off the power. To shut off the power, press the ON/STANDBY button again. If you do not wish to shut off the power, wait for a while without conducting any operations. This message will disappear after a moment. (This operation is no longer valid after the message disappears.)
2Press the ON/STANDBY button again.
When the setting of beep sound is [On], the projector |
| Remote |
beeps, and the screen disappears, but the internal | Control panel | control |
cooling fan continues to operate. Then, the projector |
|
|
goes into standby mode. |
|
|
During cooling, the ON/STANDBY indicator flashes. |
|
|
While the indicator is flashing, the power can not be |
|
|
turned back on. There is no problem with unplugging |
|
|
the power cord in this state. |
|
|
3Replace the lens cap.
After use, replace the lens cap.
Operations
Note
•The projector consumes about 4.5W of power in standby. We recommend that you unplug the power cord if you will not be using the projector for an extended period.
Precautions
•When you wish to restart the projector again right after turning off the power, give the lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.
•Right after turning off the power, the unit may become very hot, especially air exhaust, lamp cover or the bottom of the unit. Please handle with care to avoid burn injuries.
25
