Using the menus (Continued)
Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
“Yes”: displayed, “No”: not displayed
Item | Description | Computer | Y/PB/PR | Video | |
|
|
|
|
|
|
Input | Input source name | Yes | Yes | Yes | Yes |
|
|
|
|
|
|
Mode name | RGB input mode [Note 1] | Yes | No | No | No |
Resolution | Resolution (in dots) | Yes | No | No | No |
|
|
|
|
|
|
Frequency | Sync frequency | Yes | No | No | No |
|
|
|
|
|
|
Sync | Sync signal polarity [Note 2] | Yes | No | No | No |
Signal format | Y/PB/PR signal format | No | Yes | No | No |
|
|
|
|
|
|
Video mode | Color method of video signal | No | No | Yes | Yes |
Lamp time | Time of lamp use [Note 3] | Yes | Yes | Yes | Yes |
Lamp reset count | The count for lamp replacement | Yes | Yes | Yes | Yes |
|
|
|
|
|
|
Total time | The total time that this projector is | Yes | Yes | Yes | Yes |
| used. | ||||
|
|
|
|
| |
Version | Firmware version [Note 4] | Yes | Yes | Yes | Yes |
Notes
1:The mode of supported RGB signals p.53 is shown.
2:Sync signal polarity shown as P (positive) or N (negative) for [H/V].
3:Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.)
4:[Version] shows the version of the projector’s internal control program. This version will be requested for customer service purposes.
Note
•The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again.
42
