Ricoh PJ X3241 Moisture Condensation, Place and Manner of Installation, Avoid Volatile Liquid

POWER SUPPLY INFORMATION

If your line voltage is 220 to 240 V, use one of the following types of cable/plug.

Plug
configuration Plug type	Line voltage
EURO	220 – 240 V
UK	220 – 240 V

Use a 5 A fuse which is approved by ASTA or BSI to BSI362.

Always replace the fuse cover after changing the fuse.

Plug
configuration Plug type	Line voltage
Australian	200 – 240 V
240 V
10 A
Switzerland	200 – 240 V

240V

6A

North American 200 – 240 V 240 V

15 A

Before Using

IMPORTANT PRECAUTIONS

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the lens and the crucial internal parts. Do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature to prevent the unit from possible damage.

Place and Manner of Installation

•Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the projector.

•Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening their lives, and darkening the screen.

•Do not use this product in the upright position or tilt it up or down by more than 20° from level. Doing so may cause a failure or shorten the life of the product.

•Using this instrument near a TV or radio may cause interference to the images or audio sound. If this happens, move it away from the TV or radio.

•Moving the projector from a low-temperature room to a high-temperature room may cause condensation on the lens or internal parts. If you continue to use it in that situation, it may malfunction. Wait until the condensation naturally disappears.

•In a high altitude location where air is thin, cooling efficiency is reduced so use the projector with [Fan mode] set to [High]. p.41

•Only plug the power cord into outlets rated for use with the power cord’s specified voltage range. Do not overload extension cords or power strips as this can result in fire or electric shock.

•Route the power cable or the connecting cable away from where people could trip over it. The projector may fall down, which could result in severe injury.

•Be sure the power cord is easily reached for unplugging in case of emergency. Do not place any obstacles near a wall outlet in which the cord is plugged.

Avoid Volatile Liquid

Do not use volatile liquids, such as an insect spray, near the unit. Do not leave rubber or plastic products touching the unit for a long time as they will leave marks on the finish. Do not use a chemically saturated cloth.